Wire breaks are used to electrically connect two segments of the same wire which may be represented on different pages of a circuit.
From earlier, notice we had a wire break named WB-002 on Sheet 1.
Fig 14.1 Wire Break WB-002
You will now continue this part of the circuit on Sheet 2 of your circuit.
Fig 14.2 Select Sheet 2 from the Project Browser
Click on Fog Lamp Circuit Sheet 2. Now use the Wire Break In 
command. Place the Wire Break onto the blank sheet.
Click Select 
then Right-click on the Wire Break (Note clicking the Red wire connection node will bring up a different menu) and select Networks.
Fig 14.3 Wire Break Right Click Menu
Change the Network to WB-002 so that the Wire Break is linked to the existing Wire Break WB-002 and click OK.
Fig 14.4 Wire Break Properties
By using the Favourites tab, you will now add the 1-pole 1-contact Switch and Lamp onto the worksheet as shown in Fig 14.5.
To place the Ground, use the 
icon.
Fig 14.5 Sheet 2 Components
Tip: Turn guide on to better align your components. Select the 
command located at the bottom right of the screen.
Add wires to your circuit using the 
command.
Fig 14.6 Sheet 2 Completion
