40. Load Wires from a Schematic

You will now use Arcadia to automatically load the wires from the Fog Lamp Schematic.

Click on the Load Wires

command. The Load Wires Pane appears.

From the drop-down menus set Project to Quick Start Project, Schematic to Fog Lamp Circuit.

Select All when requested which properties do you want to update.

Click

Submit.

Fig 40.1 Load Wires from Schematic

Using the Load Wires from Schematic Pane you can review the wires which have been found with matching connectors in the Harness Layout. You can check/uncheck individual wires you wish to import. Click Submit to load the schematic wires into the Harness Layout.

Fig 40.2. Update Ops in Harness Toolbar

To automatically match the DEFAULT wires you placed in schematic with wires that are available in the library use the

Tool in the Harness toolbar:

Fig 40.3. Update Wire PN Form

Review the returned summary confirming which part numbers have been selected automatically in the rightmost column in Fig 40.3.

Fig 40.4. Selected Wire PN Summary

Finally close the wire Update Summary report returned which confirms the applied updates.

Fig 40.5. Updated Wire Summary

The Harness is updated. Notice the Connectors and the Wire Table located at the top left of the worksheet automatically update.

To automatically select all terminals and seals for connector in your harness use the

Tool from the Harness toolbar.

Tip: You can use the Remove Wires command to remove all wires in the Harness prior to loading wires from a schematic.