You can move the bundle by using the Move command. Select the Move command and click on either the Harness Node or the Bundle Control Node. This will allow you to pick up the bundle and move it accordingly.
You can move the Bundle End to any new Node destination if you wish to change the layout of your Harness during your design. Click the Bundle and then select the New node destination for the bundle.
Alternatively if you wish to change or move the Node you can do so with the Change Node command. Click the Node you wish to move and then Click the new destination Node to apply the change.
Also we can move the Harness Relative Simply click the Node you wish to move the harness relative to and place the Harness in its new location.
Tip: Use the Add Bend command to add additional bend to the bundle. Simply click on the Add Bend command then click on a section of the bundle to add a Bundle Control Node which can be used to drag out the bundle.
Tip: Use the Remove Bend command to remove a bend from a bundle. Simply click on the Remove Bend command and click on a Bundle Control Node for a bend.
command. Select the Move command and click on either the Harness Node or the Bundle Control Node. This will allow you to pick up the bundle and move it accordingly.
to any new Node destination if you wish to change the layout of your Harness during your design. Click the Bundle and then select the New node destination for the bundle.
command. Click the Node you wish to move and then Click the new destination Node to apply the change.
Simply click the Node you wish to move the harness relative to and place the Harness in its new location.
command to add additional bend to the bundle. Simply click on the Add Bend command then click on a section of the bundle to add a Bundle Control Node which can be used to drag out the bundle. 
command to remove a bend from a bundle. Simply click on the Remove Bend command and click on a Bundle Control Node for a bend.